Funkwerk WI2040n Bedienungsanleitung PDF herunterladen (Seite 312)

Field Description

Block after connection

failure for

Enter the wait time in seconds before the device should try

again after an attempt to set up a connection has failed. The de-

fault value is '.

Authentication Select the authentication protocol for this L2TP partner.

Possible values:

• 5+=5?+= (default value): Primarily run CHAP, on

denial, the authentication protocol required by the PPTP part-

ner. (MSCHAP version 1 or 2 possible.)

• : Only run  (PPP Password Authentication Protocol);

the password is transferred unencrypted.

• +=: Only run += (PPP Challenge Handshake Authentica-

tion Protocol as per RFC 1994); the password is transferred

encrypted.

• 5+=: Primarily run CHAP, otherwise PAP.

• ?+=/: Only run MS-CHAP version 1 (PPP Microsoft

Challenge Handshake Authentication Protocol).

• ?+=/: Run MS-CHAP version 2 only.

• 8: Some providers use no authentication. In this case, se-

lect this option.

Encryption If necessary, select the type of encryption that should be used

for data traffic to the L2TP partner. This is only possible if STAC

or MS-STAC compression is not activated for the connection. If

Encryption is set, the remote terminal must also support it, oth-

erwise a connection cannot be set up.

Possible values:

• 8: MPP encryption is not used.

• 0#2 (default value): MPP encryption V2 with 128 bit is

used to RFC 3078.

•  !"#2: MPP encryption V2 with 128 bit is

used as compatible with Microsoft and Cisco.

LCP Alive Check Check whether the reachability of the remote terminal is to be

checked by sending LCP echo requests or replies. This is re-

commended for leased lines, PPTP and L2TP connections.

16 VPN Funkwerk Enterprise Communications GmbH

300 bintec WLAN and Industrial WLAN

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 431 432

Keine Kommentare

Funkwerk WI2040n Bedienungsanleitung Seite 312